Updated Sep-2021 Test Engine to Practice Test for 4A0-100 Exam Questions and Answers!
Alcatel-Lucent Scalable IP Networks Certification Sample Questions and Practice Exam
NEW QUESTION 116
How is Ethernet II different from Ethernet 802.3?
- A. Ethernet II identifies its payload type where as 802.3 indicates the frame length.
- B. Ethernet II identifies its frame length while 802.3 indicates the payload type.
- C. Ethernet II can be used on broadcast networks where as 802.3 was designed for point-to-point networks.
- D. Ethernet II and Ethernet 802.3 are two different names for the same protocol.
Answer: A
NEW QUESTION 117
Which statement best describes an SDP?
- A. Service Delivery Points are defined on the service provider access side and used to bind the connection of the service to CE device. Many services can be bound to a single SDP.
- B. Service Delivery Points are defined on the service provider network side and used to bind the service to an MPLS transport tunnel. Only one service can be bound to a single SDP.
- C. Service Delivery Points are defined on the service provider access side and used to bind the service to CE device. Only one service can be bound to a single SDP.
- D. Service Delivery Points are defined on the service provider network side and used to bind the service to an MPLS transport tunnel. Many services can be bound to a single SDP.
Answer: D
NEW QUESTION 118
Which of the following egress interfaces is used to forward a packet with destination IP address 140.10.0.110?
- A. Interface "toP1"
- B. Interface "toP2"
- C. System interface
- D. Interface "toC1"
Answer: A
Explanation:
Section: Volume B
NEW QUESTION 119
A 24 port Ethernet switch is configured with VLAN 100 on ports 1 - 8, VLAN 200 on ports 9 - 16 and VLAN 300 on ports 17 - 24. Which of the following describes the behavior of the switch when a broadcast frame is received on port 1?
- A. The switch will flood the broadcast frame on all ports on which the switch has seen frames from attached devices
- B. The switch will discard the broadcast frame because there is no specific destination address.
- C. The switch will flood the broadcast frame on all 24 ports.
- D. The switch will flood the broadcast frame on ports 2 to 8.
Answer: D
NEW QUESTION 120 
What type of BGP sessions does router R2 need to establish in order to reach networks 192.168.1.0/27 and 192.168.5.0/27?
- A. An eBGP peering session with router R1, and iBGP peering sessions with routers R3 and R4
- B. An iBGP peering session with router R1, and an eBGP peering session with router R4
- C. iBGP peering sessions with routers R1 and R5
- D. eBGP peering sessions with routers R1, R3 and R4
Answer: A
NEW QUESTION 121
One of the tasks of the boot options file (BOF) is to:
- A. Define an IP address for the CPM Ethernet port.
- B. Initialize the hardware.
- C. Specify authorization information to control access to the router.
- D. Set the date/time for the system.
Answer: A
Explanation:
Section: Volume A
NEW QUESTION 122
What is available for auto completion of commands within the CLI on the Alcatel-Lucent 7750 SR Service Router?
- A. Type the first letters of the command, then press Ctrl C
- B. Type the first letters of the command, then press Esc
- C. Type the first letters of the command, then type ?
- D. Type the first letters of the command, then press Tab
Answer: D
NEW QUESTION 123
When a device in an IP network receives an echo request message that is destined for itself, it then:
- A. Calculates the data loss statistics.
- B. Estimates the round trip-time.
- C. Verifies the data field of the message.
- D. Generates an echo reply.
Answer: D
NEW QUESTION 124
Which of the following best describes a repeater?
- A. A device that receives a signal and based on the Layer 3 destination address makes a decision on
which ports the signal should be retransmitted. - B. A passive device simply used to connect two or more cables. It does not generate or amplify any
signals. - C. A device that receives and retransmits a signal out its ports but does not do any Layer 2 analysis of the
data. - D. A device that receives a signal and based on the Layer 2 destination address, makes a decision on
which ports the signal should be retransmitted.
Answer: C
NEW QUESTION 125
The IANA is responsible for:
- A. Allocating IP addresses for residential customer traffic.
- B. Allocation of the global IP address space.
- C. Allocating North American IP addresses .
- D. Intra-city ISP traffic.
Answer: B
NEW QUESTION 126
Which of the following statements is TRUE regarding a VPWS service?
- A. A Spanning Tree Protocol must be enabled when deploying a VPWS.
- B. VPWS is a point-to-multipoint service.
- C. VPWS requires MAC learning in order to forward frames to the correct destination
- D. VPWS treats multicast traffic similar to unicast traffic.
Answer: D
Explanation:
Section: Volume B
NEW QUESTION 127
The physical networks connecting two PCs to the internet are DSL and PPP respectively. Which layer will enable the two PCs to communicate?
- A. Layer 1
- B. Layer 3
- C. Layer 2
- D. Layer 4
Answer: B
NEW QUESTION 128
Which of the MPLS routers is responsible for pushing new labels for LSP A and LSP B?
- A. Router R4 pushes labels for LSP A, while router R1 pushes labels for LSP B.
- B. Router R4 pushes labels for both LSP A and LSP B.
- C. Router R1 pushes labels for both LSP A and LSP B.
- D. Router R1 pushes labels for LSP A, while router R4 pushes labels for LSP B.
Answer: D
NEW QUESTION 129
The statement below describes which of the following activities?
"A set of tasks that moves a packet from its entry into an IP network to its exit from the IP network."
- A. IP tunneling
- B. IP forwarding
- C. IP encapsulation
- D. IP decapsulation
Answer: B
NEW QUESTION 130
Choose two true statements that characterize Distance Vector Routing?
- A. Routers flood link information throughout the entire area.
- B. Network converges quickly (within several seconds) after a topology change.
- C. Routers do not have precise knowledge of the entire network topology.
- D. Routers send a copy of their routing table to their neighbors periodically.
Answer: C,D
NEW QUESTION 131
In the diagram, what type of BGP session is established between the routers of AS 65001 and AS 2002?
- A. EBGP
- B. IGP
- C. IBGP
- D. EGP
- E. BGP cannot be run between routers in different ASs.
Answer: A
NEW QUESTION 132
......
Certification dumps Alcatel-Lucent Certifications 4A0-100 guides - 100% valid: https://www.itpassleader.com/Alcatel-Lucent/4A0-100-dumps-pass-exam.html
100% Pass Your 4A0-100 Alcatel-Lucent Scalable IP Networks at First Attempt with ITPassLeader: https://drive.google.com/open?id=1bkoiiIfRsYEEPdcqbtg0qiPaut42KLao